📞 +91-7667918914 | ✉️ ijireeice@gmail.com
International Journal of Innovative Research in Electrical, Electronics, Instrumentation and Control Engineering
International Journal of Innovative Research in Electrical, Electronics, Instrumentation and Control Engineering A monthly Peer-reviewed & Refereed journal
ISSN Online 2321-2004ISSN Print 2321-5526Since 2013
IJIREEICE meets the suggestive parameters outlined in the latest University Grants Commission (UGC) for peer-reviewed journals, ensuring high standards of research integrity, publication ethics, and academic excellence.
← Back to VOLUME 14, ISSUE 11, NOVEMBER 2026

F1 Aerodynamic Design and Cornering Speed, Visualizer: A Verified Lifting-Line Surrogate for, Wing-Level Selection

B. Sujanaasrayan*, B. Devikiruba, M. Vishwanath, K. Sudharsan

👁 4 views📥 3 downloads
Share: 𝕏 f in ✈ ✉
Abstract: The rear wing of a Formula 1 car trades cornering grip for straight-line speed, and choosing its level normally needs CFD, wind tunnels and lap simulation. This paper presents a lightweight, verified alternative: a lifting-line surrogate that maps five wing-geometry parameters (aspect ratio, angle of attack, slot gaps, camber and reference area) to downforce and drag coefficient areas, coupled to a steady-state cornering model with tyre load sensitivity and banking that a 50-step bisection solves for the maximum apex speed. Four wing specifications were simulated at five representative corners. The spread between the high-downforce and low-drag wings grows from 0.4 km/h at a 12 m hairpin to 48.8 km/h at a 140 m corner (293.6 against 244.8 km/h, up to 4.84 g), while the high-downforce car needs 546 kW against 331 kW of drag power at 320 km/h. The solver matches the closed-form solution to four decimal places and runs a full corner analysis in about 1.2 ms. A consistency check showed that the geometry model over-predicts the preset downforce by 25–33% and that its classification thresholds mislabel three of four presets; a recalibrated area of 0.741 m² and revised thresholds give four of four. The model is delivered as an interactive Flask application verified by 22 automated tests.

Keywords: Formula 1, aerodynamics, downforce, lifting-line theory, surrogate model, cornering speed, vehicle dynamics

How to Cite:

[1] B. Sujanaasrayan*, B. Devikiruba, M. Vishwanath, K. Sudharsan, “F1 Aerodynamic Design and Cornering Speed, Visualizer: A Verified Lifting-Line Surrogate for, Wing-Level Selection,” International Journal of Innovative Research in Electrical, Electronics, Instrumentation and Control Engineering (IJIREEICE), DOI: 10.17148/IJIREEICE.2026.141105

Creative Commons License This work is licensed under a Creative Commons Attribution 4.0 International License.